Diaphragm driers

Application: 
Diaphragm driers are used to dry compressed air directly at the end point (avoiding condensation). The air must pass through a fine filter before reaching the diaphragm drier. We recommend the following filter combinations for the following scenarios: 
Model series 1: Prefilter type F 14 AM + microfilter FX 14 + 2 x coupling kit KP 1 
Model series 2: Prefilter type F 12 AM + microfilter FX 12 + 2 x coupling kit KP 2 
All diaphragm driers have their own air consumption, which is depending on pressure and size. 

Input pressure: 
4 - 12 bar 

ATEX: 
Operating material without its own potential source of ignition in accordance with Directive 2014/34/EU 

Information: 
Painting unit: build your own painting unit from pre and fine filters and diaphragm driers.

*Example: At a compressed air (not dried) inlet temperature of 25°C, the pressure dew point is 25 °C - 20K = 5°C at a flow rate of 44 l/minute with the type FMT 14-50.