2/2-way solenoid valves, NC/NO, direct-acting, G 1/8" to G 1/4", DN2.2-16

STANDARD SUPPLIED WITH PLUG

 

Materials:
Housing: Brass
Internal components: Brass / stainless steel
Seals: NBR, FKM, EPDM

 

Function:
2/2-way solenoid valve
Direct acting, normally closed (NC) or normally open (NO)

 

Thread:
G1/8″, G1/4″, G1/2″

 

Nominal diameter (DN):
From 2,2 mm to 16 mm

 

Operating pressure:
-0.95 to 16 bar
Note: depending on nominal diameter (DN)

 

Temperature range:
-10 °C up to max. +85 °C
(Types with G 1/8" and G 1/4": -10 °C up to max. +130 °C)
Ambient: -10 °C up to max. +50 °C

 

Media:
Compressed air, neutral gases, water, neutral light media, heating oil, other media on request

 

Installation position:
With upright solenoid

 

Voltages:
Standard: 24 V DC, 230 V AC
Optional: other voltages on request

 

Protection class:
IP65

 

Optional on request:
FKM seal (-10 °C up to max. +130 °C) -V
EPDM seal for air and hot water (-10 °C up to max. +120 °C) -EP
Explosion-proof** -EX

 

Note:
Servo-assisted valves require a pressure difference between the valve inlet and outlet in order to open or close. This pressure difference is specified as the minimum pressure. If pressure compensation occurs in the valve, possibly because there is no or only minimal consumption at the valve outlet, the valve will no longer function reliably.

 

• Water flow rate at +20 °C, 1 bar inlet pressure, free outlet.
  Air flow rate [l/min] approx. 13.4 × Kv × inlet pressure, when outlet pressure < inlet pressure / 2
  (Inlet and outlet pressures are absolute values in bar.)
  Specify protection class, NC valves only

Click here for more information about pneumatic valves