Pneumatically actuated check valves - stop valves

Materials:

Housing and release ring: Nickel-plated brass

Seals: NBR / plastic

Locking Jaws: Stainless Steel

(Only silicone-free seals and lubricants are used during installation!)

Temperature:

-20°C to +80°C

Operating pressure:

Max. 20 bar

Media:

Oiled and oil-free compressed air, neutral and non-hazardous gases

Working principle:

The recoil function can be used for a short stopover of a drive. If a control signal is given at the control connection, the flow rate between the banjo component and the external thread is possible in both directions. If no control signal is given, the valve shuts off the flow rate from the male thread to the banjo component (drive vent) so that it stops briefly. The flow rate from the banjo component to the male thread (to the drive) is not affected by the control signal.


Click here for more information about Push-in fittings