Pilot operated check valve G 1/4 "- 6mm, with manual emergency operation

Materials:

Body and sleeve: Nickel-plated brass, seals: NBR, holding claws: Stainless steel (only silicone-free seals and lubricants are used during assembly!)

 

Temperature range:

-20°C bis +80°C

 

Operating pressure:

max. 20 bar

 

Media:

Oiled and unoiled compressed air, neutral and non-hazardous gasses

 

Function:

The check valve function can be used for a brief intermediate stop of an actuator. If there is a control signal on the actuating connection, the flow between the banjo and male threads is possible in both directions. If there is no control signal, the valve locks the flow from the male thread to the banjo (venting the actuator), thus causing it to stop briefly. The flow from the banjo to the male threads (towards the actuator) is unaffected by the control signal.


Click here for more information about Push-in fittings

All statements are intended as non-binding guidelines! We are not liable for data selection not confirmed in writing. Pressure data, unless stated otherwise, relate to liquids from group II at +20 C.